Oil Cooler Pipe Seals Replacement

Removal Procedure

^ Tools Required
- J 41239-2 Cooler Pipe Seal Remover
- J 6125-1B Slide Hammer
- J 6471 Slide Hammer Adapter





1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the transmission oil cooler lines from the transmission. Refer to Automatic Transmission Oil Cooler Pipes Replacement.
3. Install the J 41239-2 into the cooler line seal.





4. Remove the oil cooler line seals (49). Use the J 41239-2.


Installation Procedure

^ Tools Required
- J 41239-1 Cooler Pipe Seal Installer





1. Use Mercon 11 Automatic Transmission Fluid in order to lube the seal and the transaxle bores thoroughly.
2. Install the J 41239-1 on the transmission case using cooler line bracket bolt.





3. Install a new seal in the case bore.
4. Press the new seals in. Tighten the cooler line bracket bolt until the seal bottoms out in the case bore.
5. Install the transmission oil cooler lines. Refer to Automatic Transmission Oil Cooler Pipes Replacement.
6. Lower the vehicle.
7. Check the fluid level.