Crankshaft Balancer Installation (Automatic Transmission)

^ Tools Required
- J37096 Flywheel Holding Tool
- J36660 Torque Angle Meter
1. Lubricate the seal surface of the crankshaft balancer with engine oil.





2. Install the crankshaft balancer.
3. Use J37096 to hold the flywheel.
4. Install the crankshaft balancer bolt.

NOTICE: This bolt is designed to permanently stretch when tightened. The correct part number fastener must be used to replace this type of fastener. Do not use a bolt that is stronger in this application. If the correct bolt is not used, the parts will not be tightened correctly. The system or the components may be damaged.

^ Tighten the crankshaft balancer bolt to 150 Nm (111 ft. lbs.). Use J36660 to tighten the crankshaft balancer bolt an additional 76 degrees.

NOTICE: Refer to Fastener Notice in Service Precautions.