Condenser Tube

Removal Procedure

1. Remove the air cleaner and duct assembly.
2. Recover the refrigerant.
3. Remove the brake modulator/master cylinder.





4. Disconnect the electrical connector from the A/C refrigerant pressure sensor.
5. Remove the liquid line/suction line bracket.
6. Remove the liquid line nut at the condenser.





7. Remove the liquid line nut at the orifice.
8. Remove the liquid line.
9. Remove the O-rings and discard.

Installation Procedure

Important: Coat the new O-rings with mineral base 525 viscosity refrigerant oil.

1. Install the new O-rings onto the liquid line.





2. Install the liquid line into place.
3. Install the liquid line fitting at the orifice.

Tighten
Tighten the fitting to 27 N.m (20 lb ft).





4. Install the liquid line fitting at the condenser.

Tighten
Tighten the fitting to 27 N.m (20 lb ft).

5. Install the liquid line/suction line bracket.
6. Connect the electrical connector to the A/C refrigerant pressure sensor.
7. Install the brake modulator/master cylinder.
8. Evacuate and charge the system.
9. Inspect the system for leaks.
10. Install the air cleaner and duct assembly.