SIR Coil Assembly

Remove or Disconnect

Important
- Disable the SIR system.

1. Steering wheel assembly.
2. Upper and lower steering column covers (3 screws) and snap apart.
3. multi-function lever.
4. Coil assembly retaining clip.
5. Unroute SIR coil wiring harness and cut plastic zip tie.
6. Coil assembly.

Install or Connect

NOTICE: Ensure all fasteners are securely seated before applying needed torque. Failure to do so may result in component damage or malfunctioning of steering column.

1. Coil assembly. Ensure coil assembly is centered.

Important
- Assemble pre-centered coil assembly to steering column. Remove centering tab and dispose.

Important
- Coil assembly will become un-centered if:
a. Steering column is separated form steering gear and is allowed to rotate.
b. Centering spring is pushed down, letting hub rotate while coil is removed from steering column.

2. Coil assembly using horn tower on canceling cam assembly inner ring and projections on outer ring for aligN.ment.
3. Coil assembly retaining ring.
- Ring must be firmly seated in groove on shaft.

Important
- Gently pull lower coil assembly wire to remove any wire kinks that may be inside column assembly. It is absolutely critical that you make sure there are no kinks or bends in the SIR coil assembly wire. If a kink or bend is present, interference may occur with the shaft lock mechanism. The turning of the steering wheel may cut or damage wire.

4. Route SIR -coil wiring harness and- install new plastic zip tie.
5. Coil assembly retaining clip.
6. Multi-function switch lever assembly and bolt.
7. Upper and lower steering column covers (3 screws) and snap together.

Tighten
- Bolts to 2 N.m (18 lb in).

8. Steering wheel assembly. Refer to Steering Wheel.
- Enable the SIR system.