On-Vehicle Service

REMOVAL
Remove or disconnect the following:
1. Belt.
2. Nut from bracket retaining hose on alternator.
3. Engine mount.
4. Pump bolts (3) to ease pump line removal.
5. Lines at pump.
6. Transfer pulley (if necessary).

INSTALLATION
Install or connect the following:
1. Lines at pump.
^ Tighten power steering gear inlet pipe to pump to 27 Nm (20 ft. lbs.).
2. Pump (3) bolts.
^ Tighten pump mounting bolts to 34 Nm (25 ft. lbs.).
3. Belt.
4. Engine mount.
5. Nut to bracket retaining hose on alternator.
6. Fill with fluid and bleed air from power steering system.
^ Inspect for leaks.