Parking Brake Lever: Service and Repair

Removing/Installing Parking Brake Lever Assembly:

REMOVE OR DISCONNECT
1. Lower I/P trim or sound insulator panel as needed for access to lever assembly.
2. Disable the SIR system.
3. Front parking brake cable from lever assembly after removing retaining clip.
4. Electrical connector from parking brake switch.
5. Lever assembly attaching nuts.
6. Lever assembly.

INSTALL OR CONNECT
1. Lever assembly onto dash pane1 studs.
2. Two nuts at upper rear locations and nut at lower front location. Tighten to 27 Nm (20 ft lbs.).
3. Electrical connector to parking brake switch.
4. Front parking brake cable at lever assembly.
5. Cable retaining clip.
6. Enable the SIR system.
7. I/P lower trim or sound insulator panel, as removed. Adjust Parking brake cable.