4T65-E

NOTICE: Adjust shift control cable while transaxle and gear selector are in "NEUTRAL," only. Failure to do so may cause mix-adjustment.

1. Set parking brake and chock wheels.
2. Remove shift cable terminal from transaxle manual shaft lever pin.
^ Pry on the shift cable terminal at the manual shaft lever pin with a appropriate tool. Do Not pry or pull up on any other part of the shift cable - the shift cable could be damaged.
3. Fully lift adjuster lock button. Assure the adjuster is free to move.
4. Place transaxle manual shaft lever in "NEUTRAL" gear. To find "NEUTRAL," rotate lever fully counter-clockwise to "PARK", and then clockwise 2 clicks into "NEUTRAL".
5. Place the gear shifter (inside car) in the "NEUTRAL" position.
^ Floor Shift - Use transaxle shift indicator on console to find "NEUTRAL".
^ Column Shift - Rotate shift lever to "LOW 1" position (Fully down). Push forward on lever and at the same time, push up slowly. The gear shift lever will move up while clicking over the gear over travel stops. When the lever stops solidly, it is in "NEUTRAL". Release the lever.
6. Underhood, grasp the shift cable terminal and pull it toward the pin on the manual shaft lever (the shift cable adjuster spring should compress as the terminal is moved toward the pin). Attach the pin to the lever by pushing down carefully until it snaps-do not move the lever out of position. Do Not pull terminal beyond pin then push back-this could move the shifter out of "NEUTRAL".
7. Press the adjuster lock button down flush with the adjuster body.
8. Shift to "PARK" and release parking brake while applying service brake. Start engine and assure all indicated gear positions match vehicle response.