Steering Wheel Controls and Horn Wiring

GENERAL INFORMATION
The steering wheel control switches and connector are serviced as an assembly. The horn ground and contact lead are serviced as an assembly.

REMOVE OR DISCONNECT
1. Inflator module.
2. Four screws and inflator module support plate.
3. Two screws on each side securing steering wheel control switches to support plate.
4. Steering wheel control switch assembly. Note wire routing for assembly reference.
5. Horn ground and contact lead by disconnecting from inflator module.

INSTALL OR CONNECT
1. Steering wheel control switch assembly by routing wires and securing to support plate with two screws on each side.
2. Inflator module support plate and four screws.
3. Inflator module.