Rear

Parking Brake Cable Routing And Components:

REMOVE OR DISCONNECT
1. Raise vehicle and suitably support.
2. Back off adjuster nut to release cable tension.
3. Mark position of wheel to wheel studs in bearing flange.
4. Tire and wheel.
5. Mark position of brake drum to wheel studs in bearing flange.
6. Brake drum.
7. Parking brake cable from parking brake lever.
8. Depress conduit fitting retaining tangs and remove conduit fitting from backing plate.
9. Cable from equalizer.
10. Cable from frame retaining hole.
11. Cable from rear park brake guide.

INSTALL OR CONNECT
1. Cable through rear park brake guide.
2. Cable info retaining hole; snap into place.
3. Cable to equalizer.
4. Conduit fitting into backing plate.
5. Parking brake cable to parking brake lever. Adjust
6. Brake drum, tire and wheel. Tighten Wheel nuts to 140 Nm (100 ft. lbs.). Adjust Parking brake cable.