Transaxle Mount (Front or Rear)
GENERAL INFORMATIONIMPORTANT: When replacing any transaxle mount, the remaining mount through bolts and mount bracket to cradle nuts need to be loosened, then tightened in the following sequence:
1. Rear mount through bolt.
2. Rear mount bracket to cradle.
3. Front mount bracket to cradle.
4. Front mount through bolt.
5. Left mount through bolt.
NOTE: This procedure will eliminate engine/transaxle mount preload, which could cause driveability concerns. Tighten fasteners to manufacturers specifications.
^ Tool Required:
- J 28467-360 Engine Support Fixture
REMOVE OR DISCONNECT
1. Negative battery cable.
2. Install J 28467-360 Engine Support Fixture.
3. Raise vehicle and support the vehicle.
4. Transaxle mount assembly bolts.
5. Transaxle mount.
INSTALL OR CONNECT
1. Transaxle mount.
2. Transaxle mount assembly bolts.
3. Lower vehicle.
4. Remove engine support fixture.
5. Negative battery cable.