Enabling the SIR System

(Figures 1 and 2)

Remove the key from the ignition switch.

Install or Connect

1. The Connector Position Assurance (CPA) and the yellow 2-way passenger safing connector located in the RH I/P Bussed Electrical Center (RH I/P BEC).

2. The Connector Position Assurance (CPA) and the yellow 2-way driver safing connector located in the LH I/P Bussed Electrical Center (LH I/P BEC).

3. The AIR BAG Fuse to the LH I/P Bussed Electrical Center (LH I/P BEC). Refer to Power Distribution, Cell 10 in Electrical Diagnosis in the Service Manual.

Staying well away from both air bags, turn the ignition switch to the RUN position. Verify that the AIR BAG warning lamp flashes seven times and then stays off. If the AIR BAG warning lamp does not operate as described, perform the SIR DIAGNOSTIC SYSTEM CHECK.