CB Series

REMOVAL
Remove or disconnect the following:
1. Pump assembly from vehicle, if necessary for access.
2. O-ring union fitting (16) and O-ring (15) or Variable Assist Steering actuator, if so equipped.
^ If pump is equipped with a Variable Assist Steering actuator, remove actuator (22) and discharge fitting (17).
3. Control valve assembly (13).
4. Flow control spring (12).

INSTALLATION
Install or connect the following:
1. Flow control spring (12).
2. Control valve assembly (13).
3. Lubricate new O-ring (15) with power steering fluid.
^ O-ring (15) on fitting (16).
4. Fitting (16) and O-ring seal (15) or Variable Assist Steering actuator (22), if so equipped.
^ If pump is equipped with a Variable Assist Steering actuator, install actuator (22) and discharge fitting (17).
^ Tighten fitting (16) to 75 Nm (55 lb. ft).
5. Pump assembly to vehicle, if removed.