Blower Motor Case and Insulator

Blower Assembly:

Remove or Disconnect

1. Negative battery cable.
2. Electrical connections at blower motor, ABS module, and blower motor resistor.
3. Un-clip engine harness from housing and set aside.
4. Relay housing, set aside.
5. Right inner tie rod assembly from rack/pinion assembly.
6. Loosen left side rack/pinion assembly attaching nuts.
7. Attaching nuts on right side of rack/pinion assembly and move assembly outward to gain access to lower housing cover screw.
8. Housing retaining screw from bottom of blower case.
9. Remainder of housing insulator attaching screws/nuts. (Total of 8 screws and 2 nuts).
10. Blower motor case insulator.
11. Blower motor case.

Install or Connect

1. Blower motor case.
2. Blower motor case insulator.
3. Insulator attachment screws/nuts.
4. Rack/pinion assembly attachment nuts.
5. Right side tie rod assembly to rack/pinion assembly.
6. Relay housing.
7. Engine harness.
8. Electrical connections at blower motor, ABS module, and blower resistor.
9. Negative battery cable.