Troubleshooting Hints

TRY FOLLOWING CHECKS BEFORE DOING SYSTEM DIAGNOSIS:
1. Check I/P Fuse Block 9C by operating Radio.
2. Check I/P Fuse Block Fuse 5A by visual inspection.
3. If the Driver Information Center (DIC) displays a bulb outage, always Refer to the Lamp Monitor Bulb Table before proceeding with Diagnosis. Lamp Monitor Bulb Usage Table
4. Check that all bulbs sharing same circuit are the correct type and that connections in bulb circuit are clean and tight. If all are OK, check Adaptive Lamp Monitor Module Connector for proper terminal contact. If terminal contact OK, replace Adaptive Lamp Monitor Module.
5. If a single bulb outage is not displayed by Driver DIC, check that open bulb and bulbs in parallel with open bulb are correct type. Also check Adaptive Lamp Monitor Module Connector for proper terminal contact.
^ Refer to System Diagnosis for diagnostic tests. System Diagnosis