Cylinder Head - Revised Bolt Torquing Procedure

9219oldsmobile02

NUMBER: 90-T-21

CORP.REF.NO: 906108

DATE: November 1989

SECTION: 6A


SUBJECT:
SERVICE MANUAL UPDATE - SECTION 6A - REVISED CYLINDER HEAD BOLT TORQUING PROCEDURE

MODELS/YEARS:
1989-1990 NINETY-EIGHT, EIGHTY-EIGHT AND
TORONADO EQUIPPED WITH A 3800 (VIN C) ENGINE


IMPORTANT:
This bulletin revises the cylinder head bolt torquing procedure for the 3800 (VIN C) engine that appear in 1989 and 1990 Service Manuals. The procedure for the 3800 (VIN C) is the same as that for the 3300 (VIN N). The bolt torquing sequence remains the same for both engines.

Please mark a reference to this bulletin in the following service manuals:
- 1989 Eighty-Eight and Ninety-Eight, page 6A5A-12
- 1989 Toronado, page 6A5E-11
- 1990 Eighty-Eight and Ninety-Eight, page 6A8-12
- 1990 Toronado Preliminary, page 6A8-12

INSTALL OR CONNECT

1. Clean threads in the block using a 7/16-14 tap.
2. Clean bolt threads using a wire brush.
3. Cylinder head gasket on block.
4. Apply sealant, part number 1052080 on bolt threads.
5. Cylinder head bolts.
6. Tighten cylinder head bolts to 47 N-m (35 lbs.ft.) in sequence.
7. Rotate each bolt 130 degrees in sequence using J36660 torque angle meter.
8. Rotate the center four bolts an additional 30 degrees in sequence using J36660 torque angle meter.
9. Pushrods, guide plate and rocker arm assemblies.
^ Apply Threadlock, GM part number 12345493, to rocker arm pedestal bolts before assembly.
^ Tighten rocker arm pedestal bolts to 38 N-m (28 lbs.ft.).
10. Intake manifold
11. Valve cover
12. Exhaust manifold
^ Front (left) cylinder head.
- A/C compressor bracket bolt to 70 N-m (52 lbs.ft.).
- Generator support bracket to cylinder head.
- Generator.
- C31 and spark plug wires.
^ Rear (right) cylinder head.
- Belt tensioner assembly.
- Power steering pump.
- Fuel line heat shield.
13. Negative battery cable.