Procedure to Install New Engine:

1. Install lift device.

2. Dismount engine from stand.

3. Install flywheel.

4. Install engine in car.

5. Install bellhousing bolts.

6. Connect grounds and harness bracket at bellhousing studs.

7. Connect strut bracket at radiator support.

8. Raise vehicle.

9. Connect wires at engine (bottom).

10. Install mount nuts.

11. Connect transaxle bracket at engine.

12. Install crank pulley.

13. Install flywheel to torque converter bolts.

14. Connect exhaust pipe at manifold.

15. Connect lower radiator hose.

16. Connect fuel lines at fuel pump.

17. Install lower A/C adjusting bracket.

18. Install starter.

19. Connect wires at starter.
20. Install flywheel cover.

21. Install inner fender splash shield.

22. Lower vehicle.

23. Connect fuel lines at transaxle.

24. Connect transaxle fluid fill tube at manifold.

25. Connect wire harness at rear of RH head.

26. Connect AIR hose at catalytic converter AIR pipe.

27. Connect A/C compressor to brackets.

28. Connect wires at A/C compressor and pressure cut-off switch.

29. Connect P/S pump at engine.

30. Install P/S belt and adjust.

31. Connect heater hose at water pump.

32. Install A/C belt and adjust.

33. Install AIR pump pulley and belt.

34. Install alternator belt and adjust.

35. Install exhaust crossover.

36. Install thermostat housing stud (to attach crossover).

37. Connect necessary wires at engine (top).

38. Connect necessary vacuum hoses.

39. Connect brake booster vacuum hose.

40. Connect grounds at thermostat housing.

41. Connect heater hose at thermostat housing.

42. Connect upper radiator hose.

43. Refill cooling system using original coolant. Top off coolant level as required.

44. Connect cruise cable and install bracket.

45. Connect T.V. cable.

46. Connect accelerator cable.

47. Install air cleaner, battery and hood.

48. Start engine and adjust timing and idle speed.
49. Road test vehicle.

50. Install Campaign Completion Label.