Removal and Installation

FRONT SIDE AIR BAG MODULE

Removal

WARNING: Removal of front side air bag module should only be done to allow deployment of front side air bag module prior to disposal of seatback assembly.
Only complete seatback assemblies can be replaced. Refer to "Removal and Installation".

CAUTION:
- Before servicing SRS, turn the ignition switch off, disconnect both battery cables and wait at least 3 minutes.
- Always work from the rear of air bag module.




1. Open seat back zipper to access module.
2. Pull up the seat back trim.
3. Remove the Torx nuts coated with bonding agent from front side air bag module.
4. Remove harness clips. Front side air bag module can then be removed.






CAUTION:
- Always place front side air bag module with the stud bolt side facing down.
- Do not attempt to disassemble air bag module.
- Do not insert any foreign objects (screwdriver, etc.) into air bag module connector.




- Replace front seatback assembly if it has been dropped or sustained an impact.
- Do not expose front seatback assembly to temperatures exceeding 90 °C (194 °F).
- Do not allow oil, grease or water to come in contact with the air bag module.
- After air bag inflates, the front seatback assembly must be replaced.