Front

CL25VD (Front):

REMOVAL
- If shims are rusted or show peeling of the rubber coat, replace them with new shims.
- Whenever the brake pads are replaced, the inner shim, the outer shim and the shim cover have to be replaced as a set.

1. Remove master cylinder reservoir cap.





2. Remove pin bolt.





3. Suspend the cylinder body with wire. Then remove pads with retainers, inner and outer shims and pad return springs.

INSTALLATION
1. Attach the inner shim and shim cover to the inner pad and attach the outer shim to the outer pad.
2. Apply grease to the contact surface of pad retainer with the pads, then attach the pad retainer, pads and pad return spring to the torque member.
3. Install the cylinder body to the torque member.
4. Insert a slide pin bolt (on the lower side) and tighten it to the specified torque.
5. Check the brakes for drag.