Service Manual Corrections - Engine/Controls, P/S, A/T

9217nissan01

Models: 1988 299SX

Section: General Information

Classification: GI88-002

Bulletin No.: TS88-020

Date: April 25, 1988


1988 200SX SERVICE MANUAL AMENDMENTS


The following table gives the location and a brief description of amended pages to the July 1987 (09) printing of the 1988 200SX Service Manual. Copies of these amended pages were attached to this bulletin at the time of distribution. Please note that this amended information was incorporated in following printings of the 1988 200SX Service Manual.

PAGE LOCATION UPDATE/CORRECTION
Foreward Introduction Changed to reflect 1988 model year


MA-40 S.D.S. Chart Oil and coolant capacities modified

EM-12, -13, Timing belt Procedure modified
-14 installation

EM-20 Inspection procedure Ream valve guide exhaust specifications
modified

EM-37 Illustration Water drain plug specifications chanqed

EM-50, -51 S.D.S. Chart Valve stem 'd' diameter, valve spring
and valve guide specifications modified

EM-85 & -100 Inspection procedure, Piston pin to pistons specification
S.D.S. Chart modified

EF&EC-62 Illustration Control unit terminal references
modified

EF&EC-83 Injector inspection 'B' illustration modified

EF&EC-93 E.G.R. Control in- 'A' & 'C' illustrations modified
spection(VG30E)

EF&EC-101 Air Regulator in- Illustration added for 'C' step
spection


PAGE LOCATION UPDATE/CORRECTION

EF&EC-136 Component description Pressure Regulator description
modified

EF&EC-211 E.G.R. Control in- Output Signal check modified
spection

AT-68 VG30E Schematic Check connector to kickdown switch
tie-in location changed

AT-69 CA20E Wiring Diagram Downshift solenoid harness connector
14E wire colors corrected

AT-70 VG30E Wiring Diagram Check connector to kickdown switch
tie-in location changed

ST-20 Pre-disassembly in- Pump illustration modified
spection procedure

ST-21 Disassembly procedure Steps 3-6 modified

Back Cover Engine Tune-up data Reference page correction for VG30E
idle speed specification