Transmission Position Sensor/Switch: Adjustments

PARK/NEUTRAL POSITION SWITCH AND CONTROL CABLE ADJUSTMENT





1. Set the selector lever to the "N" position.
2. Loosen the control cable to manual control lever coupling nut to free the cable and lever.
3. Set the manual control lever to the neutral position.





4. Loosen the park neutral position switch body mounting bolts and turn the park/neutral position switch body so the hole in the end of the manual control lever and the hole (cross section A - A in the figure on the left) in the flange of the park/neutral position switch body flange are aligned.

NOTE: The width of the end of the manual control lever and the flange on the body of the park/neutral position switch are the same, and so the park/neutral position switch can be positioned by hand.
In addition, the park/neutral position switch can be positioned by inserting a bar with a diameter of 5 mm into the hole at the end of the manual control lever and the hole in the flange of the park/neutral position switch body.

5. Tighten the park/neutral position switch body mounting bolts to the specified torque. Be careful at this time that the position of the switch body is not changed.





6. Gently pull the transaxle control cable in the direction of the arrow, and then tighten the adjusting nut.
7. Check that the selector lever is in the INS position.
8. Check that each range on the transaxle side operates and functions correctly for each position of the selector lever.