Fuel System Monitor

Test conditions and main points to note:
1. Conduct test drives in a manner that will ensure all the following conditions are met:
1. Engine coolant temperature: 80 - 97 °C (176 - 207 °F) or higher (with the engine fully warmed up).
2. Outside air temperature: -10 °C (14 °F) or higher.
3. Selector lever position: D range.

2. The following drive pattern (from start up to when the ignition is turned off) completes one trip monitor time required is approximately 35 minutes.)
<>1: After the engine is completely warmed up, turn off the ignition.
<>2: Start the engine and accelerate quickly until speed reaches 89 - 97 km/h (55 - 60 mph).
*3: Monitoring period: Drive for 30 seconds or more while maintaining speed between 89 - 97 km/h (55 - 60 mph). Then drive steadily and continuously for 120 seconds or more. (Accelerate and decelerate slightly during the 120 second period. Braking is permissible, but avoid sudden acceleration or deceleration.)
<>4: Decelerate and stop the vehicle. After stopping the vehicle, turn off the ignition.

Drive Cycle Pattern: