Compressor Clutch: Service and Repair

DISASSEMBLY SERVICE POINT




A NUT REMOVAL

REASSEMBLY SERVICE POINTS




A CLUTCH COIL INSTALLATION
When installing the clutch coil to the A/C compressor body, install so that the pin hole of the A/C compressor body and the clutch coil projection are aligned.




B SNAP RING INSTALLATION
Install the snap ring so that the tapered surface is to the outside.




C ARMATURE PLATE INSTALLATION
Align the mating mark of the crankshaft spline and the mating mark of the armature plate, and then fit them together.
D NUT INSTALLATION
Use the special tool to hold the magnet clutch, and tighten the nut in the same manner as removal.




E AIR GAP ADJUSTMENT
Check whether or not the air gap of the clutch is within the standard value.
Standard value: 0.40-0.65 mm (0.016 - 0.026 in.)

NOTE: If there is a deviation of the air gap from the standard value, make the necessary adjustment by adjusting the number of shims.