Cruise Control Servo Cable: Adjustments

1. Remove the link protector.
2. Check the slack in each of the inner cables in the accelerator cable, auto-cruise control cable and throttle cable. If the slack in an inner cable is excessive, or if there is no play, loosen the adjusting bolts and the nuts in the throttle lever and each link, to release the throttle lever and each link. (The bolts and nuts should not be removed.)

ACCELERATOR CABLE




1. Rotate the intermediate link A in the direction shown in the diagram, and while keeping it touching the stopper, tighten the adjusting nut in the direction to lessen the inner cable play of the accelerator cable. Then unscrew the adjusting nut the specified number of turns just before the intermediate link A begins to move.

Amount to unscrew the adjusting nut:
M/T Approx. half a turn
[inner cable play 0 - 1 mm (0 - 0.04 in.)]
A/T Approx. 2 turns
[inner cable play 2 - 3 mm (0.08 - 1.2 in.)]

2. Fix the accelerator cable with the lock nut.

THROTTLE CABLE




1. Tighten the adjusting nut in the direction to lessen the inner cable play of the throttle cable. At the position where the intermediate link B lever touches the intermediate link A unscrew the adjusting nut the specified number of turns.

Amount to unscrew the adjusting nut:
Approx. 1 turn
[inner cable play 1 - 2 mm (0.04 - 0.08 in.)]

2. Fix the throttle cable with the lock nut.
3. Tighten the throttle lever-side adjusting bolt to the specified torque.

AUTO-CRUISE CONTROL CABLE




1. Tighten the adjusting nut in the direction to lessen the inner cable play of the auto-cruise control cable. At the position where the intermediate link C lever touches the intermediate link B, unscrew the adjusting nut the specified number of turns.

Amount to unscrew the adjusting nut:
Approx. 1 turn
[inner cable play 1 - 2 mm (0.04 - 0.08 in.)]

2. Fix the auto-cruise control cable with the lock nut.