Rear

REAR BRAKE DISC THICKNESS CHECK
1. Remove dirt and rust from brake disc surface.





2. Measure disc thickness at 4 locations or more.

Standard value: 10.4 mm (0.41 inch)
Limit: 8.4 mm (0.33 inch)

Replace the discs and pad assembly for both sides left and right of the vehicle if they are worn beyond the specified limit.

REAR BRAKE DISC RUN-OUT CHECK
1. Remove the caliper support, raise the caliper assembly, and secure it by using a wire, etc.





2. Place a dial gauge approximately 5 mm (0.2 inch) from the outer circumference of the brake disc:, and measure the run-out of the disc.

Limit: 8.4 mm (0.33 inch)

NOTE: To secure the disc to the hub, tighten the nuts.