Disassembly and Reassembly

Disassembly steps
1. Voltage regulator retaining screws
2. Voltage regulator
3. Suppressor retaining nut
4. Suppressor
5. B+ terminal nut and washers
6. Through bolts
7. Slip ring end housing and stator assembly
8. Rectifier assembly retaining nuts
9. Stator assembly
10. Pulley retaining nut
11. Pulley
12. Drive end bearing retaining plate screws
13. Drive end plate
14. Drive end bearing
15. Bearing retaining plate
16. Rotor
17. Slip ring end housing bearing
18. Slip ring end housing bearing cap
19. Rectifier assembly
20. Bush
21. Slip ring assembly
22. Cooling fans

Disassembly
To disassemble follow the steps listed above and note the following :





Step 2 : Voltage Regulator Removal
Tilt the regulator slightly from the plug connection until the regulator clears the housing then lift clear.




Step 9 : Stator Removal
When removing stator, unsolder the stator leads soldered to main diodes on rectifier.

CAUTION
1. When soldering or unsoldering, use care to make sure that heat of soldering iron in not transmitted to diodes for a long period. Finish soldering or unsoldering in as short a time as possible.
2. Use care that no undue force is exerted to leads of diodes.

Reassembly
To reassemble reverse the steps listed above.