Cruise Control Switch: Testing and Inspection

AUTO-CRUISE CONTROL MAIN SWITCH CHECK
1. Operate the switch and check for continuity between the terminals
2. When the battery (+) side is connected to terminal 2 and the (-) side is connected to terminal 5, and the main switch is turned to ON, check if battery voltage is output between terminal 1 and the ground until the main switch is turned to OFF.
Next, when the main switch is turned to OFF, check if the battery voltage that was output between terminal 1 and the ground becomes 0V.







AUTO-CRUISE CONTROL SWITCH CHECK
Measure the resistance between the terminals when each of the SET RESUME and CANCEL switches is pressed. If the values measured at this time correspond to those in the table, then there is no problem.