Return

REMOVAL
1. Remove two retaining screws on rear sub-frame.
2. Reposition hose clamps and remove power steering return hose.
3. Reposition hose clamps and remove power steering return hose.
4. Remove power steering return hose fitting at power rack and pinion steering gear.
5. Remove power steering return hose at power rack and pinion steering gear.

INSTALLATION
1. Position power steering return hose at power rack and pinion steering gear.
2. Install power steering return hose fitting at power rack and pinion steering gear. Tighten to 27-34 Nm (20-25 ft. lbs.).
3. Install power steering return hose and position clamps.
4. Position power steering return hose in design position.
5. Secure with two retaining screws on rear sub-frame.
6. Fill the power steering pump reservoir with MERCON Multi-Purpose (ATF) Transmission Fluid or equivalent.