Removal and Installation

REMOVAL

1. Raise and support vehicle.
2. Remove wheel and tire assembly.
3. Disconnect electrical connector from brake pad wear sensor.
4. Remove spring retaining clip from caliper housing.
5. Remove piston housing bolts and the housing from anchor bracket.
6. Disconnect brake hose from caliper. Plug line to prevent leakage and contamination.
7. Remove caliper anchor bracket attaching bolts and the bracket, if necessary.
8. Reverse procedure to install, noting the following:
a. Torque caliper attaching bolts, brake hose and anchor bracket attaching bolts to specification.
b. Following completion of installation, perform front brake bleeding procedures.

INSTALLATION

1. Install caliper anchor bracket attaching bolts and the bracket.
2. Connect caliper flex hose to caliper.
3. Install piston housing to anchor bracket retaining bolts.
4. Install spring retaining clip to caliper housing.
5. Connect wear sensor electrical connector.
6. Torque caliper attaching bolts to, brake hose and anchor bracket attaching bolts to specification.