Shift Lever and Housing Assembly

REMOVAL

Shift Linkage:

1. Remove shift knob by pulling upward. Remove bezel assembly.
2. Remove cable retaining clip from lever and housing assembly.
3. Detach cable from lever and housing assembly.
4. Remove screw from interlock cable assembly, detach wire from bellcrank and remove cable bracket.
5. Remove four bolts which attach lever and housing assembly to floorpan.
6. Remove assembly.

INSTALLATION
1. Install lever and housing assembly into floorpan and secure with four bolts. Tighten to 4.1-9.5 Nm (3-7 ft lb).
2. Slide control cable assembly and bushing onto attaching shaft.
3. Attach interlock wire to shifter bellcrank and assemble onto pivot pin. Secure with screw to the shifter housing.
4. Position control cable assembly in lever and housing assembly. Secure by installing cable retaining clip.
5. Position bezel assembly on lever and housing assembly. Secure with four screws.
6. Position console on lever and housing assembly. Attach with four screws.
7. Install shift knob as outlined.
8. Adjust control linkage.
9. Check transaxle operation in each selector lever detent position.