Cell Phone - Installation Information: Overview

Date: May 2007

Order No.: P-I-82.70/513A

Supersedes: P-I-82.70/513

Group: 82

Update: Part number, Section N, (The new vehicle wiring harness for R171 models as of VIN 153636 requires a new contact plate.)

(Updated information will be shown with [NEW])

SUBJECT:
MODEL 171.454/456/473 equipped with SA CODE (387) (Phone System Pre-wiring)*

MODEL YEAR 2007

CELLULAR TELEPHONE INSTALLATION

WARNING
Do not disconnect the negative battery cable. Extensive reprogramming requirements will otherwise be necessary. Wiring harnesses will therefore be electrically active.

Severe vehicle damage, personal injury, or death from electrical shock could result. Exercise extreme caution while executing these installation instructions. Keep the ignition and radio powered OFF through the final test.

Notes on MOST optical fibers

^ Optical fibers damage easily-handle optical fibers with care to prevent cuts, nicks, abrasions, and crushing.

^ Optical fiber "ring configurations" must form a closed loop to function (i.e. couple the input of a component with the output of the preceding component).

^ Identify MOST optical fibers by their orange, semi-rigid insulation.

^ Electromagnetic interference (EMI) from bundled vehicle electrical harnesses does not affect optical fibers.

*Model Year 2007 R171 must be ordered factory pre-wired to accommodate the cellular telephone installation kit.

NOTICE!
Incorrect installation of connectors can result in damaged, bent pins.
Damaged, bent pins will result in component malfunction or failure.
Inspect connectors before and after installation.