Voice Activated Cell Phone/CD Changer Installation: Overview

Date: August 2000

Order No.: P-SI-82.64/140

Supersedes:

Group: 82

SUBJECT:
MODEL: 208.465/470
MODEL: YEAR 2001
VOICE ACTIVATED CELLULAR TELEPHONE/CD CHANGER INSTALLATION

WARNING:
Disconnecting the negative battery cable is not recommended due to otherwise extensive reprogramming requirements. WIRING HARNESSES WILL BE ELECTRICALLY ACTIVE. IT IS THEREFORE NECESSARY TO EXERCISE EXTREME CAUTION WHILE EXECUTING THESE INSTALLATION INSTRUCTIONS. FAILURE TO DO SO. COULD RESULT IN SEVERE VEHICLE DAMAGE. PERSONAL INJURY OR DEATH FROM ELECTRICAL SHOCK. The ignition and radio power must remain OFF until the final test is performed.

Application specific D2B notes:

^ CD changer, telephone, and voice recognition module fibers are installed at the factory. Telephone and voice recognition fibers run along the left rear quarter panel and CD fibers along the right rear quarter panel.

^ TeleAid 2 fibers are installed at the factory only if the vehicle is equipped with COMAND.

^ The vehicle is configured from the factory for the CD changer only.

^ Telephone and voice recognition fibers are individual pairs that run along the left rear quarter panel. They are coupled together just before the battery to the right side. While not in the configured ring, they are connected together assuming the voice recognition module will be installed along with the telephone. The fibers must be reconfigured if only the telephone will be installed.

^ All reconfiguration points are in the trunk in front of the battery and to the right of the fuse panel.