Model 129

1. Remove carpeting from center console.

2. Cut and remove all styrofoam from underside of carpeting. Remove material from lip around the underside of carpeting so reinforcing plate can lie flat.





3. Place reinforcing plate on back of carpeting (Figure 4).

4. Locate, punch and drill tour inner holes to 5 mm.

5. Insert four screws through reinforcing plate and carpeting. Mount charger-holder on carpeting and tighten screws.

6. Drill outer holes through carpeting to match the diameter of the mounting plate holes.

7. Remove two forward screws in center console compartment.

8. Place angular bracket in console with raised edge of bracket pointing towards the rear of the compartment. Secure bracket using the two removed screws.

9. Locate two harnesses at rear of compartment. A coaxial antenna connector is taped to a 12-pole data cable labeled PORTABLE PHONE. The other 12-pole data cable is not labeled.

10. Connect antenna adapter cable (arrow, Figure 4) between antenna harness and pigtail on back of charger-holder. Connect harness labeled PORTABLE PHONE to charger-holder.





11. Replace carpeting and charger-holder into center console compartment, routing the harness along right side of compartment. Secure carpeting with two screws (arrows, Figure 5) to angle bracket in compartment.