Replacement Procedure
MODEL 124with CODE (305a) Dust filter
with CODE (581a) Air conditioning (Automatic)
1 Dust filter
2,3 Clamping brackets
4 Seal
5,6 Lip seal
7 Clips
8,9,10 Screws
11,12 Air inlet
15 Center pant
NOTE: Image shown is with windshield wiper system removed.
Removal and Installation:
1. Pull off seal (4) up to windshield wiper
2. Remove lip seals (5, 6)
3. Remove center part (15) (2 clips)
4. Remove left water drain (Clips 7, screws 8)
5. Lift out air inlet (11) towards the top, (screws 9,10).
6. Remove air inlet (12) screws (10) and lift out towards the top.
7. Fold down clamping brackets (2).
8. Lift up dust filter (1), pull out towards the left side. If necessary assist via right opening.
9 Pull dust filter (1) towards the front. Then pull out towards the left side. When re-installing, make sure the dust filter halves are correctly positioned in clamping brackets 2 and 3. Both dust filter halves must be properly engaged at their separation joint.
10. Installation is in the reverse sequence, noting the tip in step 9.