Rear

Fig. 9 Cross-sectional View Of Teves Type Rear Caliper:

1. Open caliper bleeder screw and pump brake fluid from rear brake circuit.
2. Disconnect frame floor holder brake hose from caliper assembly. Cap all open lines, Fig. 9.
3. Remove caliper attaching bolts, then the caliper from disc rotor.
4. Reverse procedure to install, noting the following:
a. Calipers from different manufacturers may be installed on the rear axle, however, the calipers used must have the same caliper piston diameter.
b. Carefully connect all brake lines and/or hoses.
c. Check brake system for leaks.