Computers and Control Systems: Technical Service Bulletins
- Customer Interest
- By Symptom
- All Technical Service Bulletins
- Engine Control - Engine Control Module (N3/10) Flashing
- Hand-Held Tester (HHT) - Updated Modules
- Policy - HHT Warranty & Precautions
- Fuel - EFI Analyzer Test Sheet
- Scan Tool (Impulse Counter ) - Failure, Improper Hook-Up
- Battery Discharged/Electronic Damage - After Jump Start
- Engine - Stalls Then Restarts/Cuts Out During Coasting
- Engine - Hesitates/Cuts Out/Quits/Difficult to Start
- Stalling and/or Cutting Out Complaints
- Engine Hesitates, Cuts Out, Hard Start
- Electronic Components - Warning Against Repair
- Idle Speed at Times Too High or Low
- MIL ON ON/OFF Ratio Unadjustable After Repair Work
- Policy - Replacement Conditions of ECU After Accident
- Engine Cuts-Out, Cannot Be Restarted
- Engine is Difficult to Start, Cold or Warm
- Engine Does Not Start
- Engine - Difficult to Start Cold and Warm
- Engine Surges in Idle at Operating Temperature
- Fuel - Idle Speed Air Valve Design Change
- Overvoltage Protection Relay - Modified For ABS
- Idle Speed - Installing Harness and Resistor
- Engine Surges at Idle at Operating Temp.