Rear Wiper Motor Inspection

REAR WIPER MOTOR INSPECTION

1. Disconnect the negative battery cable.

2. Remove the liftgate lower trim.

3. Disconnect the rear wiper motor connector.

4. Apply battery positive voltage to rear wiper motor connector terminal C, and connect terminals B and D to the ground.

5. Verify that the rear wiper motor operates smoothly.






- If there is any malfunction, replace the rear wiper motor.

6. Disconnect the ground connecting rear wiper motor connector terminal D and the negative battery terminal while the rear wipers are operating, then verify that the rear wipers stop at the auto-stop position.






- If there is any malfunction, replace the rear wiper motor.