Transmission Speed Sensor: Testing and Inspection

Input/Turbine Speed Sensor Inspection

Note: Input signals of the input/turbine speed sensor can be inspected with a NGS tester.

Resistance Inspection
1. Disconnect the negative battery cable.
2. Remove the air cleaner component.





3. Disconnect the input/turbine speed sensor connector.





4. Measure the resistance between the terminals of the input/turbine speed sensor.
^ If not as specified, replace the input/turbine speed sensor.
Resistance 250 - 600 ohms (ATF temperature: -40 - 160°C (-40 - 20°F))
5. Connect the input/turbine speed sensor connector.
6. Install the air cleaner component.
7. Connect the negative battery cable.