Air Bag Modules Deployment Authorization Procedures

1. Install a new SAS control module.
1. Turn the ignition switch to the ON position.
2. Verify that the air bag system warning light illuminates for approximately 6 seconds, goes off, and then flashes continuously.
- If the air bag system warning light does not flash continuously and indicates a DTC, inspect the system using the on-board diagnostic function.
When the malfunctions have been repaired and the air bag system warning light flashes continuously, turn the ignition switch to the LOCK position. Wait for approximately 1 second or more and then turn the ignition switch back to the ON position.
- If the air bag system warning light flashes continuously, turn the ignition switch to the LOCK position. Wait for approximately 1 second or more and then turn the ignition switch back to the ON position.

2. Verify that the air bag system warning light illuminates for approximately 6 seconds and then goes off.
- If the light stays on, perform the deployment authorization procedure again.