Air Bag Modules Deployment Authorization Procedures

1. Install a new SAS control module.
2. Turn the ignition switch to ON
3. Verify that the air bag system warning light illuminates for approximately 6 seconds, goes out, and then flashes continuously.
* If the air bag system warning light does not flash continuously and indicates a diagnostic trouble code, inspect the system using the on-board diagnostic function. (Refer to AIR BAG SYSTEM ON-BOARD DIAGNOSIS.)
* When the malfunctions have been repaired and the air bag system warning light flashes continuously, go to step 4.
* If the air bag system warning light flashes continuously, turn the ignition switch to LOCK and back to ON after more than approximately 1 second.

4. Verify that the air bag system warning light illuminates for approximately 6 seconds and then goes off.
* If the light stays on, perform the deployment authorization procedure again.