Intake Manifold: Service and Repair
REMOVALRemove components in order shown, referring to REMOVAL NOTES. Inspect parts and replace as needed.
View: Intake Air System Components:
1. Strut bar
2. Fresh-air duct
3. Air cleaner housing
4. Resonance duct
5. Volume airflow sensor
6. Air intake hose
7. Accelerator cable
8. Throttle body
9. Spacer
10. By-pass air control (BAC) valve
11. Intake manifold
12. Air intake pipe
REMOVAL NOTES
View: Fuel Pump Connector Under Rear Seat Cushion:
1. Before disconnecting fuel distributor, relieve fuel pressure.
View: Coolant Drain Plug:
2. Drain coolant before removing water hose from BAC valve.
INSTALLATION
Install in reverse order of removal. Refer to INSTALLATION NOTES.
INSTALLATION NOTE
View: Air Intake Pipe:
Air Intake Pipe
1. Apply small amount of clean engine oil to O-rings.
2. Install the air intake pipe carefully without damaging the O-rings.
3. Tighten the bolts to specified torque in the order shown in the figure.
Torque: 7.9 - 10.7 Nm (70 - 95 in.lb.)