Clockspring Assembly / Spiral Cable: Service and Repair

After completion any on vehicle service procedure, verify system operation by checking airbag warning lamp. If system is operating normally, the warning lamp will come on when the ignition switch is turned On, then go Off after approximately 6 seconds.

The clock spring connector assembly is part of the combination switch.
1. Disconnect battery ground cable.
2. Remove knee protector, then disconnect clock spring/combination switch connectors.
3. Remove airbag module, refer to AIRBAG MODULE.
4. Using suitable puller, remove steering wheel.
5. Remove combination switch attaching screws, then the combination switch.
6. Remove clock spring from combinations switch.
7. Reverse procedure to install, noting the following:
a. Set front wheels in straight ahead position.
b. Turn clock spring connector clockwise until it stops. Do not force it.
c. Turn clock spring connector counterclockwise 2-3/4 turns.
d. Align marks on clock spring connector and outer housing.