Shift Linkage: Adjustments

Adjustment





1. Remove the splash shield next to the left front tire.
2. Remove the square head plug L and install the SST.
3. Shift into P range and start the engine. Warm-up the engine to normal operating temperature, and adjust the idle speed if necessary.

Idle speed: 750 +/- 25 rpm





4. Adjust the locknuts as follows:

Note: Transmission in P range.

When the locknuts are moved, line pressure is increased or decreased as shown. Adjust the locknuts to the correct position using the following procedure.

(1) Initially install the locknuts fully away from the throttle cam. (Loosen the cable fully)
(2) Adjust the locknuts in a clockwise direction as viewed from the passenger side of the vehicle until the line pressure begins to increase above the specification shown below.





(3) Adjust the locknuts in a counterclockwise direction until the line pressure decreases to the specification.

Adjustment pressure:441 kPa (4.5 kg/m2, 64 psi)

(4) Tighten the locknuts and verify that the line pressure is as specified.

Specified pressure: 432-451 kPa (4.4-4.6 kgmcm(2), 63-65 psi)

5. Turn off the engine.
6. Reinstall the square head plug.
Tightening torque: 5-10 Nm (50-100 cm-kg, 43-87 in-lb)





7. Fully open the throttle valve; then crimp the pin with the protector installed as shown.
8. Remove the protector.