Axle Shaft Assembly: Service Precautions

Halfshaft Handling

Caution:
^ Never pick up or hold the halfshaft only by the inboard or outboard CV joint.

Caution:
^ Do not over-angle the CV joints.

Caution:
^ Damage will occur to an assembled inboard CV joint if it is over-plunged outward from the joint housing.

Caution:
^ Never use a hammer to remove or install the halfshafts.

Caution:
^ Never use the halfshaft assembly as a lever to position other components. Always support the free end of the halfshaft.

Caution:
^ Do not allow the boots to contact sharp edges or hot exhaust components.

Caution:
^ Handle the halfshaft only by the interconnecting shaft to avoid pull-apart and potential damage to the CV joints.

Caution:
^ Do not drop assembled halfshafts. The impact will cut the boots from the inside without evidence of external damage.

Handle all halfshaft components carefully during removal and installation procedures.