Removal and Replacement
Removal and InstallationWARNING: All safety belt assemblies including retractors, buckles, front seat belt buckle support assemblies (slide bar), shoulder belt height adjusters (if so equipped), child safety seat tether attachments, and attaching hardware should be inspected after any collision. All belt assemblies should be replaced unless a qualified technician finds the assemblies show no damage and operate properly. Belt assemblies not in use during a collision should also be inspected and replaced if either damage or improper operation is noted.
WARNING: If the side air bag sensor is subjected to shock or the sensor is disassembled, the side air bag module may operate (deploy) suddenly and cause injury, or it may fail to operate normally and cause a serious accident. Do not subject the side air bag sensor to shock or disassemble the sensor.
1. Disconnect the battery ground cable and wait at least one minute. For additional information, refer to BATTERY DISCONNECT.
2. Remove the safety belt. For additional information, refer to SAFETY BELT BUCKLE - CENTER AND PASSENGER SIDE, REAR, in this section.