Procedure # 2

REAR DOOR NON-FUNCTIONAL - LATCH REPLACEMENT

Removal

1. Remove the rear seat cushion.

2. Remove door trim panel according to Workshop Manual (section 09-17 INTERIOR TRIM).

3. Position aside the water shield.





4. Reach in with a small screwdriver and insert screwdriver into latch assembly at outside base of electrical connector below metal actuating lever and pry up.

NOTE:
If lever will not move freely, cycle the door lock button and door handle to free lever.

5. Remove rear door latch according to Workshop Manual (section 09-14 SECURITY AND LOCKS).

Installation

1. Install new latch according to Workshop Manual (section 09-14 SECURITY AND LOCKS).

2. Install door trim panel according to Workshop Manual (section 09-17 INTERIOR TRIM).

3. Install rear seat cushion.

4. Verify repair.