Brake Caliper Anchor Plate

Brake Caliper Anchor Plate

Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Disconnect the rear parking brake cable and conduit. For additional information, refer to Parking Brake System.

3. Remove the axle shaft. For additional information, refer to Differential Assembly &/or Axle Shaft Assembly.

4. WARNING: Use tools, not fingers, to hold flagnuts. Flagnuts may slip or spin unexpectedly when removing fasteners. Failure to follow this instruction may result in injured fingers.

Remove the 4 retainers and the brake caliper anchor plate.
- To install, tighten to 68 Nm (50 lb-ft).

5. To install, reverse the removal procedure.