System Reactivation Procedures

1. Disconnect the battery ground cable.

WARNING: The air bag simulators must be removed and the air bag modules installed and reconnected when the system is reactivated to avoid non-deployment in a collision, resulting in possible personal injury.

2. Wait at least one minute for the backup power supply in the Restraints Control Module (RCM) to deplete its stored energy.
3. Remove the air bag simulator from the vehicle harness connector at the top of the steering column.
4. Install the driver air bag module.

WARNING: Carry a live air bag module with the air bag and trim cover pointed away from your body. This will reduce the risk of injury in the event of an accidental deployment.

5. Remove the air bag simulator from the vehicle harness connector at the passenger air bag module.
6. Connect the passenger air bag module electrical connector.

WARNING: Carry a live air bag module with the air bag and deployment door pointed away from your body. This will reduce the risk of injury in the event of an accidental deployment.

7. Remove the air bag simulator from the vehicle harness beneath the passenger seat.
8. Reconnect the passenger side air bag module electrical connector beneath the passenger seat.
9. Remove the air bag simulator from the vehicle harness beneath the driver seat.
10. Reconnect the driver side air bag module electrical connector beneath the driver seat.
11. Reconnect the battery ground cable.
12. Prove out the system.