Driver Side Air Bag Module

REMOVAL

NOTE: If the driver side air bag module did not deploy in a collision, it may not have been needed. Complete all diagnosis before replacing the driver side air bag module.

WARNING: The electrical circuit necessary for system deployment is powered directly from the battery. To avoid accidental deployment and possible personal injury, the positive battery cable must be disconnected prior to servicing or replacing any system components.

1. Disconnect positive battery cable and wait one minute for backup power supply to deplete its stored energy.
2. Remove four nut and washer assemblies retaining air bag module to steering wheel.






3. Disconnect the air bag electrical connector from air bag sliding contact connectors. Remove driver side air bag module.

INSTALLATION
1. Connect the driver side air bag module wiring connector to air bag sliding contact connector.
2. Position driver side air bag module to steering wheel and secure with four nut and washer assemblies. Tighten to 4-5.6 Nm (35-50 in lbs).
3. Connect positive battery cable.
4. Verify air bag indicator.