Selector Lever Cable and Bracket - Floor Shift
Selector Lever Cable and Bracket - Floor ShiftRemoval
1. Lift and remove the floor shift PRNDL trim plate.
2. Using a small flat-blade screwdriver, lift up on the shift knob bezel and remove the bezel.
3. Remove the two shift lever knob screws and remove the knob.
^ Slide the knob button out when the knob is removed.
4. Remove the spring from the top of the selector handle.
5. Position the window regulator control panel aside.
6. Remove the screws and the console finish panel.
7. Disconnect the transmission shift cable from the transmission selector arm.
8. Remove the left side console access panel.
9. Remove the transmission shift cable retaining clip from the floor shift mechanism through the console access panel.
10. Push the rubber grommet and transmission shift cable through the floor panel.
11. With the vehicle in NEUTRAL position it on a hoist.
12. Remove the transmission shift cable from the automatic transmission.
13. Remove the shift cable bracket from the transmission.
^ Remove the bolts and the shift cable bracket.
Installation
1. To install, reverse the removal procedure.
^ Adjust the shift cable.