Seat Control Switch - 8-Way
SEAT CONTROL SWITCH - 8-WAYRemoval
WARNING:
- The safety belt pretensioner is a pyrotechnic device. Always wear safety glasses when repairing an air bag equipped vehicle and when handling a safety belt buckle pretensioner or safety belt retractor pretensioner. Never probe a pretensioner electrical connector. Doing so could result in pretensioner or air bag deployment and could result in personal injury.
- To reduce the risk of personal injury, do not use any memory saver devices.
NOTE:
- If a seat equipped with a seat mounted side air bag and/or a safety belt pretensioner (if equipped) system is being serviced, the supplemental restraint system (SRS) must be depowered.
- The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
- The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
- Driver side shown, passenger side similar.
1. Remove the affected seat and depower the SRS.
2. Pry to remove the two power seat knobs and remove the knobs.
3. Access and remove the front side shield screw.
4. Pull out from the bottom and rear side of side shield to release the three retainer clips.
5. Disconnect the power lumbar switch and 8-way power seat switch electrical connectors.
6. Remove the three screws and remove the power seat switch.
Installation
1. Install the power seat switch and install the three screws.
2. Connect the 8-way power seat and power lumbar switch electrical connectors.
3. Push to install the three side shield retainers onto the seat frame.
4. Access and install the front side shield screw.
5. Install the two power seat knobs.
6. Install the affected seat and repower the SRS.